• In charge of pre-shutdown planning • Ability to perform the work safely and independently. • Ability to dismantle and assemble each and every compressor and turbine component as per checklist. • Ability to take alignment readings using Laser Alignment kit and interpret the readings and correct them. • Ability to carry out shaft run-out check, bearing/ labyrinth clearances and document them in the check list. • Ability to read & understand Equipment manuals, Datasheets etc and work per the procedures • Ability to take readings using various measuring tools and interpret them against the technical data from the manual. Ability to handle hydraulic tools for coupling, thrust collar removal etc. • Ability to read drawings and instruction, to install /remove rotating equipment or parts. • Assist in preparing Job Safety Analysis • Ability to identify and use proper tools during overhauling. • Ability to identify any safety related problems and technical problems and notify immediately to immediate supervisor. Desired Candidate Profile • Must have good knowledge of SAP software and pre-shutdown planning works. • Must have good knowledge of safety requirements in Petrochemicals, Oil & Gas industries. • Must have minimum 10 years of work experience as Compressor/ Turbine Technician in a Petrochemical, Oil & Gas Plant. • Must have Working experience & Knowledge in repair and overhauling of various multistage HP Centrifugal compressors (Horizontally spilt & Barrel type) of make GE-Nuovo Pignone, Mitsubishi, Dresser Rand, etc. • Must have Working experience & Knowledge in repair and overhauling of various multistage Special purpose Steam Turbines (Condensing/ Back Pressure/ Extraction) of make GE-Nuovo Pignone, Mitsubishi, SIEMENS, ABB etc. • Must have worked on at least 3 to 5 Compressor / Steam turbine overhauls as hands on lead technician. • Working experience in removal and installation of john crane make dry gas seals on the compressors will be advantage. • Working experience in Shutdown and Turnaround will be preferred. • Knowledge of rigging signal and basics in compressor rigging work will be added advantage. • Must be able to operate overhead cranes for removing & installing rotors / casings and other components of compressor and turbines. • Typical Plant experience will be an added advantage.